Parts Breakdown; Drill Setup - KOBE DMM3050i Operator's Manual

PARTS BREAKDOWN

KOBE
I N D U S T R I A L
POWER TOOLS
8

DRILL SETUP

KOBE
I N D U S T R I A L
POWER TOOLS
SECURING THE DRILL (Fig.5)
When working horizontally or overhead, the Drill should
always be secured using a safety strop or the chain
supplied. The safety securing chain has a spring carabine
hook to facilitate anchoring the drill either direct to the
steelwork or to a webbing strop.
Remember - the drill must only be used on steel with a
thickness of 6mm or above.
COOLANT SUPPLY
The Drill comes complete with a gravity feed coolant bottle.
The pipe fits directly into the fitting on the side of the
Weldon Adaptor a shown in Fig. 6. The bottle has a wire
hook around the neck for attaching to the top of the slide as
shown in Fig.7 or suspended from the securing chain as
shown in Fig.7a when the drill is being used in the
horizontal plane on steelwork as it needs to be kept above
the working position of the drill.
Fig.7
Fig.7a
Fig.5
Fig.6
5