Drill Operation; Box Contents - KOBE DMM3050 Operator's Manual

KBE-268-4220K_Instructions.qxd 29/09/2011
KOBE

DRILL OPERATION

I N D U S T R I A L
POWER TOOLS
DRILL POSITIONING
Mark the position of holes to be
drilled with a centre punch prior to
putting the Drill into position.
Insert a small pilot drill into the
drill and lower until it's point is in
line with the bottom of the base.
Place the drill into position above
the mark left by the centre punch
then switch on the magnet with
rocker switch (a) to hold in
position.
DRILLING
Check the position of the pilot drill
above the mark and then switch
the Drill on by pressing the Green
Button (b). If required, turn on the
tap to supply coolant. Wind the
drill down using the handle in the
direction of arrow (c) and apply
gentle pressure to start the drilling
e
process.
IMPORTANT:
Let the drill do the work, do not
use excessive force as this may
damage the Drill and or the bit.
When you have drilled the hole,
back out, rotating the handle in the
direction of arrow (e) and switch
off the drill by pressing the Red
button (d). Replace the pilot drill
with the correct size bit for the
hole you require and then drill the
hole slowly so as not to create
excessive heat and blunt the bit.
For larger holes, you may need to
drill with an intermediate sized bit
before the correct sized one in
order to stop the bit binding in the
hole whilst the hole is drilled.
8
12:36 Page 5
Fig.2
c
b
d
a
KOBE

BOX CONTENTS

I N D U S T R I A L
POWER TOOLS
Save the packaging material for future transportation of the Mag Drill in
the event of service or repair.
Drill
Coolant
feed pipe
13mm
Chuck
Guard
Hanging
Coolant
hook
bottle
Coolant tap
Guard fixings
Chuck
key
Hexagon Keys
Safety securing chain
Fig.1
5