Plumbing; Freshwater Storage Tank; City Water - Winnebago Towables User Manual

FRESHWATER STORAGE
TANK
Water is stored in an onboard storage tank and
is distributed to the various faucets by an
automatic, self-priming pump which is operated
by the 12-volt electrical system. This pump will
function when power is available and the pump
switch is "ON".
Instructions to fill with a gravity fill:
This water storage tank is filled through a grav-
ity fill (if equipped) special filler cap outside the
vehicle.
1. Before filling the tank, turn the pump switch
to "OFF".
2. Open the filler cap on the outside of the trailer.
3. Pour the water in from a bucket, or use a hose.
4. When the tank is full, close the cap before
turning the pump switch to "ON".
Gravity Fill
Instructions to fill without a gravity fill:
1. Connect a garden hose to the city water
connection located on the docking station.
2. Turn the selector valve to the tank fill location.
3. Do not turn the water pump to the ON
position.
4. Turn on the water supply line and the tank will
begin to fill.
SECTION 7 – PLUMBING
5. Please do not walk away from the RV while
the tank is being filled.
6. Once the tank is filled, turn the water supply
OFF.
7. Turn the water valve to System Use position.
At this setting your water pump will draw
water from the Fresh water tank when needed.
Selector Valve
Docking Station
CAUTION
Overfilling the freshwater tank from a
pressurized source may cause serious
damage to the water tank or structural
components. Monitor water tank filling
continuously.

CITY WATER

Water, under pressure, is provided when the
trailer is connected to a park or city water supply.
Connect the trailer as follows:
1. Turn the 12-volt water pump to "OFF".
2. Remove the protective cap on the city water
fill and connect a hose between the city water
supply and the city water fill on the trailer.
7-1