Table of Contents
Advertisement
3.16 HANDLEBAR LOCK
Activation
With the handlebar turned to the left, insert the key completely and
turn it anti-clockwise (Fig. 23).
Disengagement
Turn the key clockwise.
Fig. 23
3.17 STANDS
3.17.1 CENTRE STAND
•
The centre stand position is not electronically controlled; there-
fore you can turn the engine on while the vehicle is parked. To
place the vehicle on the stand, push pin A and raise the vehicle
using the grab rail on the rear side of the saddle.
During this manoeuvre, hold the vehicle in place to pre-
vent it falling over.
english
3.17.2 SIDE STAND
•
It is on the left side of the vehicle (B - Fig. 24); it is controlled by
a micro switch that prevents the engine starting if the stand is
not properly closed.
Do not remove nor tamper with this safety device.
We advise you to regularly check the retaining system of
both stands. This system is composed of tension springs.
Always make sure that both stands are on a firm and
levelled ground. Soft or gravely soils, asphalt which be-
comes soft in the heat, etc. may cause the parked vehi-
cle to fall.
Do not sit on the vehicle while it is parked on one of the
two stands.
B
A
Fig. 24
23
1
2
3
4
5
6
Hide quick links:
Advertisement
Table of Contents
