Subscribe to Our Youtube Channel
Related Manuals for AMTC EQ-AMP40W
Summary of Contents for AMTC EQ-AMP40W
- Page 1 EQ-AMP40W 40W Mixer Amplifier Instruction Manual 4091 AMTC Center Drive Clearwater, FL 33764-6976 (727)531-3105 (727)531-3965 www.amtc.com...
- Page 2 Features 1. MIC 1 input with front- and rear-panel connectors 2. Rear-panel MIC 2 input 3. Rear-panel AUX input 4. Line-level outputs allow connection to another amplifier 5. 100V and 70V constant-voltage speaker outputs and 4-16 ohm constant- resistance speaker output 6.
- Page 3 Frequency Response (@ 1 kHz Half Power Output, +- 3dB): 40 Hz - 18 kHz MIC1-2 Input Section (Ch. 1-2 in @ 1 kHz, Preamp Out): Input Sensitivity / Impedance: 2 mV / 600 ohms S/N: Better than 62 dB Frequency Response (+-3 dB): 40 Hz - 18 kHz Tone Control (Bass: 100 Hz, Treble: 10 kHz): +-12 dB AUX Input Section (AUX In @ 1 kHz, Preamp Out):...
- Page 4 Front Panel Power Indicator Monitor/MOH Output Level Control Knob Bass Tone Control Knob Treble Tone Control Knob MIC1 Input Level Control Knob MIC2 Input Level Control Knob AUX1 Input Level Control Knob Protection Indicator LED (Indicates protection mode. Turn off amplifier, and check for short circuit in speaker wiring or excessive speaker load.) LED Level Indicator MIC Input (1/4”/6.3mm) (Do not use if rear panel MIC input jack is used)
- Page 5 Rear Panel 1. MIC Interrupt Time Adjustment (adjusts from sharp to gradual the restoration of AUX inputs after interruption by front panel MIC input) 2. MIC 1 Dual Input (XLR & 1/4”/6.3mm)(do not use if front panel MIC 1 jack is used 3.
- Page 6 11. Monitor/MOH Output (for use with monitor speaker or telephone music on hold input) 12. 110V AC Power Input with ? replaceable fuse...
- Page 7 Usage Notes 1. Do not power on the amplifier until all input sources and speakers are securely connected. Turn the volume knob to its minimum setting before powering on the amplifier to prevent speaker damage. 2. The total power consumption rating of the speakers must not exceed the amplifier’s continuous power rating.
- Page 8 Object and Liquid Entry: Care should be taken so that objects do not fall and liquids are not spilled into the unit enclosure through openings. Damage Requiring Service: The unit should be returned to AMTC when: The power supply cord or the plug has been damaged; or Objects have fallen, or liquid has spilled, into the unit;...
- Page 9 Liability for any defect is limited to repair or replacement of this product at the option of AMTC. AMTC shall not be liable for damage to other products caused by defects in this product, damages based on inconvenience or loss of use of this product, or any other damages, whether incidental, consequential or otherwise.
Need help?
Do you have a question about the EQ-AMP40W and is the answer not in the manual?
Questions and answers