Table of Contents
Advertisement
IP Power Manager XL-IPM401 User's Guide
2 Installation
2.1 Hardware & Software installation
Before you start to use XL-IPM401, please follow the steps below
Check the package to make sure the contents is complete.
Prepare one Ethernet HUB or Router
Check the voltage of the power supply to make sure it is AC 110-240 volt
Please confirm the specification of your power cable.
Please use the 10A power cable.
2.2 Hardware installation
1. Connect the XL-IPM401 to HUB through network wire.
2. Connect the HUB or Router to the internet (may through ADSL/XDSL modem).
3. Connect the power adapter to the XL-IPM401.
4. Connect the power adapters of under control electric equipment to corresponding out port of XL-IPM401.
Turn on your computer and the power adapter of XL-IPM401.
Please note: use power wire can support 10A current (for 240V AC).
Max. output current: (total) 10A, (individual) 6A.
7
www.xtendlan.com
Advertisement
Table of Contents
