KNX Technical Reference Manual
®
ABB-i-Bus
-KNX Millenium
Note
The following parameters are available only when parameter "Control type cooling" is set on "PI
continuous", or on "FanCoil".
Additional parameters for "Control
function = Cooling"
Control value difference PI continuous for
sending of the control value cooling
Note
The following parameters are available only when parameter "Control type cooling" is set on "PI
continuous", or on "PI PWM (1-bit)".
Additional parameters for "Control
function = Cooling"
PWM cycle cooling (min)
KNX Technical Reference Manual | 1473-1-7819
Settings
• deactivated
• 2 %
• 5 %
• 10 %
Settings
1 ... 60
Description of applications /
Comments
–
Comments
–
objects
— 39 —