Table of Contents
Advertisement
KNX Technical Reference Manual
®
ABB-i-Bus
-KNX Millenium
8.5.2
Deactivation
1. Press the "On/Off" button (6).
2. ´The device switches to the "Off" state.
All buttons are no longer backlit.
Note
All buttons are deactivated.
The device has no function in a deactivated state!
8.6
Temperature
8.6.1
Display of the set-point temperature
The temperature appears automatically in the display.
For this the device must be switched on!
8.6.2
Setting of the set-point temperature
The currently set room temperature can be indicated via the display.
If the rotary control element is actuated, the set-point temperature is shown in the display. Whenever the set-point
temperature is unequal to the actual temperature, the indication changes from white to orange or blue. Here the
background is appropriately coloured and the indication is black.
1. Press the button "Set value adjustment" (3).
Observe the colour change! (See also chapter "LED
colour concept" on page 20.).
2. Turn the rotary control element.
–
to the right:
warmer
–
to the left:
colder
3. Set your desired temperature!
4. Press the button "Set value adjustment" or wait until the
set time expires.
The adjustment is stored.
After operating the device there is an automatic jump-back to the set-point temperature display after an adjustable
time. The set-point temperature can be adjusted again by turning the rotary control element. This equally applies
when the button "Set value adjustment" is pressed again.
KNX Technical Reference Manual | 1473-1-7819
Fig. 11:
The device is deactivated
Fig. 12:
Device in set value adjustment
Operation
— 22 —
Advertisement
Table of Contents
