Advertisement
Quick Links
X-CAM X100B 2 Axis Brushless Gimbal For GOPRO
Accessories
Photo Gallery
User Manual
X-CAM X100B 2 Axis Brushless Gimbal has been finished all adjusting before leaving the
factory, Users just need to assemble to the aircraft, the pitch of holes is 59mm
Parameters:
Weight: 235g (Supports GOPRO1-3)
Sensor resolution: 0.015
Motor travel limited: +-90 degree
Input voltage: 12V ( Recommend using 12V BEC )
●
1 x X100B Gimbal frame with motors
●
1 x 2 Axis brushless controller (Assembled)
●
1 x 3 in 1 connection wire
●
1 x Lint paster
Advertisement
Summary of Contents for X-cam X100B
- Page 1 X-CAM X100B 2 Axis Brushless Gimbal For GOPRO User Manual X-CAM X100B 2 Axis Brushless Gimbal has been finished all adjusting before leaving the factory, Users just need to assemble to the aircraft, the pitch of holes is 59mm Parameters: Weight: 235g (Supports GOPRO1-3) Sensor resolution: 0.015...
-
Page 2: Connection Direction
Connection Direction Uses the 3 in 1 connection wire to connect with your receiver One wire connect to Gimbal Tilt Control Channel ( use the wire which has the GND ) One wire connect to the AIL Channel One wire connect to the ELE channel If you are using a receiver which is no PPM channels such as Futaba 6203 then you can not use this function... -
Page 3: Sensor Calibration
The Lint paster must be used if using the GOPRO3 Please use a TAPE to fix the camera mount and make sure it is hard enough Do not run the X100B without GOPRO Make sure the center of gravity of GOPRO is at the correct position... - Page 4 Acc. Gain: After adjusting the Pos. Gain, Inclined the gimbal to one position quickly and watch the image is horizontal in time, if not just adjust the Acc. Gain. Notice: the X100B has been finished the adjusting, does not need to adjust again in normally...
- Page 5 Gimbal Control The X100B provides 2 ways to control the TILT, Linear Mode or Tracking Mode Linear Mode: Push the TILT stick to high or low for moving the camera mount to up or down until the stick back to midpoint Tracking Mode: Push the TILT stick to high or low, the camera mount will follow the stick position.
- Page 6 Disclaimer Do not disassemble the X100B and the electronic components Any direct or indirect damage caused by the users , we do not assume liability or assume compensation.