Page 1
X-CAM A22-3H for SONY NEX5 3 Axis Gimbal User Manual X-CAM A22-3H has been finished with all the adjustments before launch the market, READY TO RUN. Parameters Weight: 680g(withoutCamera&Lens) Stabilizationfrequency: 5200Hz Inputvoltage: 11.1v~22.2v(3S~6SLipo) Tilttravel: +-90degree;Rollingtravel:+-45degree YAW travel: 360degreeswithunlimitedrotation Built-inHDMItoAVModule AutoPilotSystemsupportingisnotrequired SupportLens: 16mmFixed(Default), 16-50mm,16mm+0.75 wideangle SupportCamera:SONYNEX5Series(Default)、NEX7、BMPCC、SONYA5000、A6000 Accessories ●...
Page 2
Uses the USB adapter to connect with your PC , Normally the Windows can find the driver automatically, you could find the PORT number in the device Manager Launch the X-CAM Gimbal Stabilization Module Assistant , choose the correct port number and click CONNECT...
BEEP BEEP will be shouted after the connection succeed, the parameters will be read out automatically. The parameters as below: Gains There are 2 gains, Position Gain and Acceleration Gain Pos. Gain: Inclined the gimbal to one position slowly and watch the image is horizontal or not, if not just adjust the Pos. Gain. Acc.
Ifthescreenframeisstill nothorizontalthenyouhavetosetthe“Sensor Calibration”, inputtheX,Y,Z offsetvalueandclick “SensorCalibration” GYRO Calibration Make sure the gimbal in quietude and click “GYRO Calibration”, this function will reduce the error which comes from the environment temperature Please notice these setup must be set very carefully, we strongly recommend set these parameters with X-CAM supporting.
内置 HDMI 转 AV 模块 Initial Settings: 1. Set the camera HDMI output to auto resolution mode. 2. Set the video mode to infrared remote control mode. 3. Connect RCD3015G HDMI converter with the camera, connect the servo cable of shutter controlling with the remote control receiver. 4.
Open the firmware file ( *.bin ) Click “Load and Connect” button Turn on the X-CAM A10-3H, it will upgrade the firmware automatically Notice: Please do not touch anything and keep the power on during the upgrade, if the upgrade is break please back to STEP 1 and try again, normally it could be fix automatically.