Polaris ATV 2001 Owner's Manual page 150

MAINTENANCE
Oil Filter and Change
Xpedition 425
1. Place vehicle on a
level surface.
2. Run engine two to
three minutes until
warm.
engine.
3. Clean area around
drain plug.
4. Place a drain pan
beneath
crankcase and remove drain plug. CAUTION: Oil may be hot.
Do not allow hot oil to come into contact with skin as serious
burns may result.
5. Allow oil to drain completely.
6. Replace sealing washer on drain plug. NOTE: The sealing
surfaces on drain plug and crankcase should be clean and free
of burrs, nicks or scratches.
7. Reinstall drain plug and torque to 14 ft. lbs. (1.9 kgm).
8. Place shop towels beneath oil filter. Using an oil filter wrench,
turn filter counterclockwise to remove.
9. Using a clean dry cloth, clean filter sealing surface on
crankcase.
10. Lubricate O-ring on new filter with a film of engine oil. Check to
make sure the O-ring is in good condition.
11. Install new filter and turn by hand until filter gasket contacts the
sealing surface, then turn an additional 1/2 turn.
139
Stop
engine
Oil Drain