Table of Contents
Advertisement
MAINTENANCE
Choke Adjustment Procedure 4-cycle Engine
Push/Pull Choke
1. Locate the boot behind the
choke knob and pull it
back. Loosen the friction
nut 1 turn or until choke
slides freely.
boot.
2. Push the choke knob in to
the full off position.
3. Slide boots off in-line cable adjuster and loosen adjustment
locknut.
4. Turn adjuster until the choke knob pushes out over 1/4".
5. Push on the choke knob lightly while turning the adjuster the
opposite way.
6. Turn the adjuster until the knob contacts the boot.
7. Tighten adjuster locknut.
8. Slide boots back over the cable adjuster until they touch at the
middle of the adjuster.
9. Pull back the choke knob boot and tighten the friction nut until
the choke will maintain a set position. Re-install boot.
Boot
129
Re-install
Adjuster
Sleeve
s
Locknut
Boot
Hide quick links:
Advertisement
Table of Contents
