Qtx PAJ-12A Manual

Before using your new PAJ-12A powered speaker, please read this
instruction manual to prevent any damage or personal injury. Keep
it away in a safe place for future reference.
NOTE: Before connecting the speaker to a power outlet, make sure the
speaker amplifier is off and the controls are on the minimum level. Otherwise
the speaker may be damaged when power is turned on.
Quick Set-Up Instructions:
1.- Plug a IEC power cable from a wall power outlet, to the PAJ-12A.
2.- Plug a Microphone into the "MIC" input (1a, 1b) with a 6.35mm or
XLR connector.
3.- Plug an auxiliary system (CD, DJ Mixer, MP3, DVD, etc) into the
"LINE IN" input.
4.- Turn on the speaker amplifier on by flicking the "Power" switch (9). A
green LED will light up to indicate that is on.
5.- Set the volume of the MIC and LINE IN inputs to "12 o'clock".
6.- Gradually increase the "MASTER" volume (3) until the desired
loudness is reached.
7.- Set TREBLE and BASS controls to equalise the sound.
8.- A red LED will light up on the front of the speaker if the system
detects an overload, or peak signal. In this case you must reduce the
volume level of the MIC or LINE inputs, and /or the MASTER volume.
Caution
Do not point a microphone towards the speaker, it can cause
feedback to occur which can damage both the speaker and
human ears.