Related Manuals for Qtx QR12PA
Summary of Contents for Qtx QR12PA
- Page 1 QRPA Portable PA Units Order ref: QR12PA (178.843) QR15PA (178.846) User Manual VERSION 4.
- Page 2 Caution: Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty Introduction QRPA portable PA units Thank you for choosing the QR series portable PA unit. Please read this manual prior to use to avoid damage to the item.
-
Page 3: Specifications
Cleaning Use a soft cloth with a neutral detergent to clean the cabinet, panel and controls. To avoid damage, do not use solvents to clean this equipment. Specifications QR12PA QR15PA Power supply 220-240Vac 50/60Hz / external 12Vdc / internal battery Main driver 30cm (12”) -
Page 4: Operation
Operation Connection Your new QTX QR-series portable PA unit may arrive with you with the internal battery charged. Before connecting to the mains, switch the unit on and see if the power LED lights. If not, you will need to charge the battery before using away from a mains supply (see “Charging the battery”... - Page 5 Your QR-series PA unit should now be ready to operate. VHF Wireless Microphones For QR12PA and QR15PA, insert the supplied 9V batteries into the handheld microphones by carefully unscrewing the base of each and connecting the “+” and “-“ terminals or the battery to the corresponding clips inside the microphone body, taking care to observe the correct polarity.
-
Page 6: External Inputs
External Inputs In addition to the unit’s own VHF microphones, 6.3mm jack inputs are provided to connect external wired or wireless microphones, which are both governed by the MIC VOLUME control. If required, the music level can be automatically muted when speaking into a microphone by switching the VCV on. -
Page 7: Charging The Battery
In addition to the panel controls, an infra-red remote control is provided for the USB/SD player which adds some further functions to allow greater control over the media player. To operate, remove the clear plastic tab from the remote to activate the battery. Charging the battery When not in use but connected to the mains, if the POWER switch is in the position, the... -
Page 8: Troubleshooting
Troubleshooting Check POWER switch is on Check battery is not drained fully No output and no LEDs lit Check mains lead is connected Check mains or D.C. fuse hasn’t blown Check 9V batteries in wireless transmitters Check wireless transmitters are switched on Power LED lit but no VHF Check VHF POWER is switched on output...