Accessories; Optional Accessories - WERTHEIM 7000 Instruction Manual

ASSEMBLY STEPS - Refer to visual steps on pages 5-9 if required.
The cleaner should be switched off and disconnected from the mains supply before
commencing assembly.
• Connect the hose body connector to the cleaner
• Insert the wand into the powerhead
• Press the release button on the telescopic tube to extend or retract to desired length
• Fit the other end of the telescopic tube to the hand piece
• To detach tube from powerhead, press down on the release pedal with your foot

ACCESSORIES

Your Wertheim 7000 comes with a powerhead, a deluxe combination fl oor tool, a mini turbo
brush and crevice tool, a dust brush and a blower attachment.

OPTIONAL ACCESSORIES

• Hard Floor Tool
POWERING YOUR WERTHEIM 7000
If you are using your machine without the powerhead and are using any of the other tools
you only need to turn on the power for the machine (not the powerhead).
The switch on the handle is used when you have the powerhead on.
The switch on the powerhead allows you to turn off the rotating brush. (You may not want
to change the fl oor head, but are using on a hard fl oor & don't want the brush rotating).
• Pull the power cord out from the rear of the vacuum and plug into a power socket
(Never extend the power cord further than the yellow mark)
• Press the On/Off button to switch the appliance on
• When you are fi nished using the appliance, unplug from the power socket and press the
power cord retract button to retract the power cord
CORRECT FLOOR SETTING
Deluxe Combination Floor Tool -
ADJUST POWER SETTING
To adjust the suction from the machine, rotate the variable speed dial. MIN setting to reduce
the suction, and MAX setting to increase the suction.
10
Has two fl oor settings. One for hard fl oors and the other
for carpeted surfaces. To adjust the setting, press down
on the fl oor tool lever.