Nacra FCS Owner's Manual page 13

6. Attached the Harken 40 mm Swivel, Becket, Cam Cleat
block with the shackle to the deck pad-eye.
Be aware you can adjust the
cam cleat angle to your de-
6
sired angle. As illustrated be-
low
7. Attached with the supplied pins and Harken instructions
attached the 29 mm Pivoting Lead Block
ed on the deck next to the daggerboard-case.
to its base mount-
7
8. Lead the extrension line through the daggerboard pull up
blocks to create a 4:1 purchase.
Do NOT overload the daggerboard pull-up block
purchase at any time. Hereby avoiding under load-
ing the shrouds of the mast rigging, as it may
cause structural damages and/or breakage.
Make sure the halyard is pulled 'block to block'
when the daggerboard is fully up onshore to avoid
this problem during sailing.
SHROUDS
8
CAUTION!
9. Pull the extension trim line through the daggerboard
pull down system as illustrated above. Tie the end with a
bowline knot on the 29mm deck block as illustrated be-
low.
9
13