Table of Contents
Advertisement
Fig. 14 Removing the retaining split pin
[1]
Hinge pin
[2]
Retaining split pin
B Pull the hinge pin (
Fig. 14, [1]) upwards out of the hinge.
B Unhook the rocker arm (
Fig. 15, [3]).
B Release the compression spring (
(
Fig. 15, [4]).
B Remove the compression spring.
B Fit the compression spring on the left hand side.
B Fit the washer (
Fig. 15, [2]).
B Fit the Allen screw.
B Pre-tighten the Allen screw until the washer has a clearance of 60 mm
towards the boiler front panel.
B Hook in the rocker arm.
B Pivot the rocker arm over the compression spring.
Uni Condens 6000F
2
1
6 720 648 053-31.1T
Fig. 15, [1]) with Allen screw
1 2
3
Fig. 15 Installation
[1]
Spring
[2]
Washer
[3]
Rocker arm
[4]
Screw
B Slightly undo the screws for the door stays on the left hand side until
the door stays can be moved in the slot.
B Push the hinge pin on the left hand side from above through the hinge
in the door stay and the door until it reaches the rocker arm.
B Fit the retaining split pin through the hinge pin below the lower door
stay ( Fig. 14).
B Push the upper door stay on the left hand side to the left and tighten
the screws.
B Push the lower door stay on the left hand side to the right and tighten
the screws.
The hinge pin has no more play and the combustion chamber door will
not drop when opened.
B Remove the four door screws.
B Pivot the combustion chamber door open by 90°.
B Release the compression spring with the Allen screw until the hinge
pin lies in the lower door stay at the front of the slot.
The combustion chamber door is hanging straight in the hinge.
5.6
Fitting the burner (accessory)
NOTICE: System damage through incorrect burner.
B Only use burners that meet the technical
requirements of the Uni Condens 6000F
(
chapter 2.11, page 7).
5.6.1 Fitting the burner plate
Predrilled and undrilled burner plates are available
(accessories).
The installation method depends on the particular
burner used.
B Remove the protective plate from the combustion chamber door.
B Secure burner plate [3] with gasket [2] to combustion chamber door
[1] using hexagon bolts and washers [4].
Installation | 19
4
6 720 648 053-37.1T
6 720 803 637 (2012/03)
Advertisement
Table of Contents
