Installation Detail
When a heater is installed outdoors without the presence of an adequate eave, then a protective cover must
be installed as illustrated below. This cover is available from your local dealer (Part # RS020).
Cover Installation Sequence
Install support brackets on to heater covers as shown in step 1 in Figure 7.
Pre-assemble the cover and its top covers and bottom cover as shown in step 2 in Figure 7.
Remove the two top screws holding the reflector in place.
Slide cover onto burner making sure the support brackets slide into slots on the bottom cover.
Secure cover to heater by screwing in the cover bracket in step 3B in Figure 8.
Install the extension covers (Front, Back, and Side) as shown in step 4 in Figure 8 if needed.
Left Support
Bracket, Install
Screw on
Top Hole
When a heater is to be installed outdoors at 45° without the presence of an adequate eave, an extension
cover must be used to protect the heater, refer to step 4 in Figure 8. This extension cover is available
through your local SRP Dealer (Part # RS021). Note that both the cover and extension cover must be used
in this case.
3
3
A
Note:
Close all open ended "S" hooks, chain links,
and turnbuckles or any open connection.
Series GR
1
Right Support
Bracket, Install
Screw on
Bottom Hole
Figure 7: Cover Installation Sequence Steps 1 and 2
B
Attach Cover
Bracket
Back
Install 45°
Extension
Covers
As Shown
Figure 8: Cover Installation Sequence Steps 3 to 5
Cover
4
Side
Page 12
2
Install Both
Top Covers
As Shown,
Then Install
Assembly on
to Heater
Install Bottom
Cover As Shown
5
Front
February 10, 2014