Installation Preconditions - Panasonic KX-TDA0480 Installation Manual

Physical Installation

3.1 Installation Preconditions

Verify that the following conditions are met before proceeding with the installation.
Electromagnetic Interference
This equipment can cause electromagnetic interference to nearby unshielded equipment. Take
care to protect nearby equipment that may be affected.
Installation Location
The KX-TDA0480 must be installed at appropriate slot of IP PBX.
Cabling
Several cables of appropriate lengths will be needed during the installation process. The
lengths will depend on the specific installation.
• 10 Base-T (RJ45) cable will be needed to interconnect the KX-TDA0480 with routers,
hubs, and/or Ethernet switches.
• For each unit port in use, a 2-wire printed inter-office cable will be needed to connect
the KX-TDA0480 to its respective terminal devices (e.g., ordinary telephone sets and/or
a G3 fax machine.)
The following table indicates the specifications for these cables.
Cable type
Printed intra-office
cable
10BaseT (RJ45) cable
Installation Data
The worksheets completed in the preceding section of this guide must be on hand to perform
the physical and logical installation tasks described in this and the following section.
Maintenance Console Software Terminal
During the logical installation process described in the next section, a computer terminal will
be needed to run the Maintenance Console Software. In addition, the RS-232C serial cable
described in Section 3.3 Connect the Computer Terminal Unit with RS-232C Cable will be
required to initialise the unit.
If units are to be configured remotely following initialisation, a LAN cable and appropriate
adapters will also be needed to connect the terminal to the network.
42
Cores Diameter
2-wire
0.5 mm
Remarks
KX-TDA0480 to
Ethernet connection
Installation Manual