Panasonic KX-TDA0480 Installation Manual page 19

Gatekeeper for Maintenance Console Software procedures to configure this information in the
KX-TDA0480.
A reproduction master for this worksheet is included in Appendix A8.
• This worksheet contains all of the information needed to initialise a network's KX-
TDA0480 using the Maintenance Console Software Unit Setup Wizard.
• If this setup information is uploaded to each unit and the units are rebooted, it is possible to
perform all remaining configuration tasks remotely using the Maintenance Console
Software.
Group Name Unit Name Unit IP Address
NY01
New York
New York NY02
San Francisco SF01
SF02
San Francisco
Los Angels LA01
Los Angels LA02
Group Name
Use the Group Name field to assign a group in which to create and store the KX-TDA0480 in
the Maintenance Console Software. Subgroups can also be created. The procedure for creating
Groups is discussed in Section 4.6 of this document.
Each KX-TDA0480 must be assigned to a Group. The New Group command is used to enter
this information in the Maintenance Console Software. Although the Maintenance Console
Software requires that this be done before units (Gateways) can be defined, it is used for unit
identification only and is not recorded in the unit's configuration file (OFDD.VHO).
DNS information is stored in the unit's DNS.DAT file.
The Group Name field allows for entry of an unrestricted alphanumeric string.
For convenience, the Group Names in the sample worksheet are designated as the names of the
cities in which the units will be installed.
Installation Manual
IP Gateway Network Units List Worksheet
Subnet Mask
IP Address
133.149.1.91
255.255.255.0
133.149.1.92 255.255.255.0
206.184.223.95 255.255.255.0
206.184.223.96
255.255.255.0
206.45.11.34 255.255.255.0
206.45.11.35 255.255.255.0
Route IP Route IP
Address 1 Address 2
133.149.1.1
133.149.1.1
206.184.223.1
206.184.223.1
206.45.11.1
206.45.11.1
Planning
Signal
port no.
1720
1720
1720
1720
1720
1720
19