Motorola EX-3524 Installation Manual page 16

16
4. Verify basic switch operation by observing the system LEDs. For normal operation, both the DIAG and PWR
LEDs should be solid green.
5. Install the SFP transceivers and connect the cables to the port interfaces.
• For RJ-45 ports, use 100-ohm category 3 or better Ethernet cable for 10BASE-T connections, use 100-ohm
category 5 or better Ethernet cable for 100BASE-TX and 1000BASE-T connections.
• Install SFP transceivers and then connect fiber optic cabling to the transceiver ports.
• Status LEDs should be clearly visible.
• Ensure that twisted-pair cables are always routed away from the power lines, fluorescent lighting fixtures
and other sources of electrical interference.
To make basic configuration changes before connecting the switch to the network, see
page 24.
EX-3524/EX-3548 Layer 2 Gigabit Ethernet PoE/PoE+ Switch
Switch Management on