Desa VYGF33PRA Owner's Operation And Installation Manual page 17

INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL ACCESSORIES (GHRCB and
GHRCTB)
Installing Remote Receiver Unit
1. Disconnect switch wires from the control valve.
2. Remove screws attaching switchplate.
3. Remove switch plate (see Figure 33). Discard after removing.
4. Install remote receiver unit onto gas log heater base using
mounting clips.
5. Push clips firmly into place (see Figure 34).
6. Connect wires as shown in Figure 35.
Remote
Switch
Bracket
Screw
Switch Plate
Figure 33 - Switch Plate and Wiring Harness
Mounting
Clips
Figure 34 - Installing Remote Receiver
White Wire
From
Receiver
Figure 35 - Connecting Wires
For more information, visit www.desatech.com
For more information, visit www.desatech.com
105270-01H
Ignitor
Wires
Remote Receiver
Valve
Red Wire From
Receiver
Optional Wireless Hand-Held Remote Control Accessories
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required to operate this
heater with the wireless hand held remote control set. Install one
battery in the receiver and one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of heater.
2. Locate the battery clip mounted on the back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Remote
Receiver
Figure 36 - Installing Battery in Remote Receiver
Installing 9-Volt Battery in Hand-Held Remote
Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery. Place battery into the bat-
tery housing.
3. Replace battery cover onto remote control unit.
Model
GHRCB
Terminal
Wires
9-Volt
Battery
Figure 37 - Installing Battery in Hand-Held Remote Control Unit
INSTALLATION
Battery Clip
9-Volt Battery
Battery
Cover
Remote
Control Unit
Battery
Housing
17
17
Terminal
Wires
Model
GHRCTB