Advertisement

Assembly Manual
Mountain Bike

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mountain Bike and is the answer not in the manual?

Questions and answers

Summary of Contents for Cube Mountain Bike

  • Page 1 Assembly Manual Mountain Bike...
  • Page 2: Table Of Contents

    Assembly Manual Mountain Bike Assembly Manual Mountain Bike I. Unpacking the box II. Getting the front wheel ready III. Fitting the front wheel IV. Fixing the front wheel into the fork V. Adjusting the handlebars VI. Fitting the saddle VII. Fitting the pedals...
  • Page 3: Assembly Manual

    Assembly Manual Mountain Bike Dear Customer, Congratulations on the purchase of your new mountain bike. Attention: It is essential that you also read the manufacturers’ own operating manuals to With the aid of this Assembly Manual you will be able to fully understand all of the technical features of your bike.
  • Page 4: Unpacking The Box

    Assembly Manual Mountain Bike I. Unpacking the box Open up the package of accessories and take out the quick release skewer. (Fig. 2) Open up the special shipping box and remove the rectangular protective cardboard on the rear wheel. Take the wheel out of the box, followed by the saddle and then the bike frame, which has the rear wheel already fitted.
  • Page 5: Fitting The Front Wheel

    (when sitting on the bike) Lift the mountain bike by its stem with one hand Remove the shipping protection from the hydraulic disc brakes, by pulling the plastic out of the disc brake calliper (Fig.
  • Page 6 Wheel with mechanical V-brakes Lift the mountain bike by its stem with one hand Fit the front wheel in the direction it is to rotate Fig. 8...
  • Page 7 Assembly Manual Mountain Bike Important: Check that the front wheel is rotating freely. Close the quick release skewer on the hub - more about this under Point IV The wheel has not been fitted properly if the wheel is not...
  • Page 8 “Close” is facing outwards (Fig. 18) Fig. 15 Fig. 16 Lift up the mountain bike with one hand Fit the front wheel in the direction it is to rotate Important: You may need to let some pressure out of the inner tube to fit the front wheel in correctly.
  • Page 9: Fixing The Front Wheel Into The Fork

    Assembly Manual Mountain Bike IV. Fixing the front wheel into the fork b.) Using a stub axle Remove the stub axle from the packet of accessories a.) Using a quick release skewer Loosen the stub axle screw using the correct Allen key on your...
  • Page 10: Adjusting The Handlebars

    Assembly Manual Mountain Bike Fig. 24 Fig. 25 Fig. 26 Attention: Make sure that there is an even tightening torque on all of the stem locking screws. The clearance of the stem Fig. 22 Fig. 23 clamp has to be identical, otherwise there is a risk of a serious material defect on the handlebars! V.
  • Page 11: Fitting The Pedals

    Assembly Manual Mountain Bike Attention: Ensure when adjusting the height of the saddle that the seat pin is not pulled out further than the maximum height! Failure to comply with this could result in serious material defects or accidents! (Fig. 30) VII.
  • Page 12: Test Run

    Important: Before heading out, please check that all of the features of your bike. screw fittings and quick release skewers on your mountain bike are tight. Test out the suspension to ensure that it is working correctly and has sufficient suspension tension.
  • Page 13 Assembly Manual Mountain Bike Space for notes:...
  • Page 14 Assembly Manual Mountain Bike Space for notes:...
  • Page 15 Assembly Manual Mountain Bike Space for notes:...

Table of Contents

Save PDF