Table of Contents
Advertisement
ACE PLUS CORP.
DIP Switch
Pin#1
OFF
Position
Use Default
EDID Mode
Note
1
Set pin#1-ON[ ] first and then connect the HDMI Input to HDMI display thru HDMI cable. Wait
for 20 seconds. The Recording Procedure will be finish. If you want to learn the EDID for
another equipped display, you must set pin#1-OFF[ ] and repeat the procedure.
2
If the equipped display shows video but without audio, please try to set audio to 2 channel.
Rotary Control
In order to adapt the CAT5 cable, EX-G016A offers 8 level equalization control on the
received HDMI signal. The strongest equalization is applied while the knob stops at
number 0, while the weakest equalization happens at number 7. It is recommended to
switch from 7 to 0 to find the optimal visual experience.
HDMI Output Format Selection
When input signal exists, the output format LED turns on. If the input HDMI source is HDMI 1.3
format, you can set the output format to HDMI 1.2 mode and Red LED will be on. If the input HDMI
source is HDMI 1.2, the output format is always set to HDMI 1.2.
Page 6 of 9
[ ]
[ ]
ON
Use learned
EDID
EDID
Pin#2
Position
Audio Mode
1
Headquarters :
9F-2., No. 190 Sec. 2 Jung Shing Rd.,Hsin-dian,
Taipei, Taiwan 231
TEL: +886-2-2912-4201
FAX: +886-2-2912-3164
Website:
www.ace-plus.com
www.ace-plus.tw
[ ]
[ ]
OFF
ON
7.1
Stereo
2
Channel
Advertisement
Table of Contents
