Table of Contents
Advertisement
Quick Links
© 2010 Horizon Hobby, Inc.
ParkZone
products are distributed exclusively by Horizon Hobby, Inc.
®
DSM and DSM2 are trademarks or registered trademarks of Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Spektrum radios and accessories are exclusively available from Horizon Hobby, Inc.
Futaba is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan.
www.parkzone.com
Created 4/10 17298 PKZ5180 PKZ5175
Advertisement
Table of Contents
Related Manuals for PARKZONE Extra 300 PNP
Summary of Contents for PARKZONE Extra 300 PNP
- Page 1 © 2010 Horizon Hobby, Inc. ParkZone products are distributed exclusively by Horizon Hobby, Inc. ® DSM and DSM2 are trademarks or registered trademarks of Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Spektrum radios and accessories are exclusively available from Horizon Hobby, Inc.
-
Page 2: Instruction Manual
Extra 300 PNP/BNF Instruction Manual Charge-and-Fly Park Flyer ™... -
Page 3: Safety Precautions And Warnings
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language: The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND little or no possibility of injury. -
Page 4: Table Of Contents
SPMR6600 or SPMR7700) for the Extra 300 BNF. Transmitter, ® designed in 1987 by Walter Extra. The Extra 300 is one of the receiver, charger and battery required for Extra 300 PNP. most recognized full-scale aerobatic aircrafts in the world. WARNING: Although your ParkZone® Extra 300 comes... -
Page 5: Low Voltage Cutoff (Lvc)
Low Voltage Cutoff (LVC) The Extra 300 receiver features a soft low voltage cutoff (LVC) minimum operating voltage so flight controls do not respond that occurs when the battery reaches 3V per cell under load. to the transmitter. When the soft cutoff occurs, the electronic speed control (ESC) Stay aware of the power level of the battery/aircraft throughout and receiver reduce power to the motor (regardless of the the flight, and when the aircraft requires more throttle than... -
Page 6: Charging The Flight Battery
• Charges 2- to 3-cell Li-Po packs with minimum capacity of 300mAh 3S 11.1V 2200mAh Li-Po Battery Pack The ParkZone 3S Li-Po battery pack features a balancing lead that allows you to safely charge your battery pack when used with the included ParkZone Li-Po balancing charger. -
Page 7: General Assembly And Maintenance Tips
General Assembly and Maintenance Tips Note: This checklist is not a replacement for the content included in this manual. Although it can be used as a quick start guide, we strongly suggest reading through this manual completely before proceeding. First Flight Preparation Activity PNP BNF ... -
Page 8: Transmitter And Receiver Binding
Transmitter and Receiver Binding Binding is connecting a transmitter to an aircraft receiver wirelessly or electronically so the aircraft receiver recognizes the transmit- ter GUID (Globally Unique Identifier) code. Binding is necessary for proper operation. The Extra 300 requires a DSM2 full range (high power) transmitter. The list below is Spektrum™ or JR® DSM2-equipped full range transmitters and modules that can bind to the Extra 300’s receiver: •Spektrum DX5e •Spektrum DX6i... -
Page 9: Installing Landing Gear
Installing Landing Gear Note: Fairings (PKZ5130) may be removed for flying the 3. Install left (marked “L”) and right (marked “R”) landing Extra 300 from a rough runway gear fairings on the landing gear supports and fuselage using four (4) small screws. 1. -
Page 10: Installing Wings
Installing Wings 1. Put the wing tube in the round hole in the wing slot of the 6. Attach the two (2) aileron connectors to the aileron Y-harness fuselage. in the fuselage. 2. Put left wing on the wing tube. 3. -
Page 11: Installing Horizontal Tail And Pushrods On Control Horns
Installing Horizontal Tail and Pushrods on Control Horns Installing the Horizontal Tail Installing Pushrods on Control Horns 1. Put the horizontal tail (PKZ5125) in the fuselage, making CAUTION: The installation positions of the pushrods sure the control horn is on the right side of the fuselage. The and clevises directly affect aircraft response. -
Page 12: Installing The Flight Battery
The CG location is 3.00 inches (76mm) back from leading edge of the wing at the root +/- 1/4 inch (6.4mm). This CG location has been determined with the ParkZone 2200mAh 11.1V 25C Li-Po battery installed in the middle of the battery cavity. -
Page 13: Control Direction Test
Control Direction Test and Reverse Controls Note: This Control Direction Test does not describe Mode 1 or 5. When the transmitter rudder stick is pushed to the left, the Mode 2 transmitter control assignment. Refer to transmitter rudder should move to the left. instructions for information about Mode 1 and Mode 2 control assignment. -
Page 14: Control Surface Travel Measurement
Control Surface Travel Measurement Factory Setting for Control Surface Travel Factory settings for the DX5e transmitter are Dual rates set at 100% on high rate and at 70% on low rate. These dual rates cannot be changed on the DX5e. All controls surfaces are set for 100% adjustable travel volume (ATV). -
Page 15: Installing Propeller Adapter, Propeller And Spinner
Installing Propeller Adapter, Propeller and Spinner Note: The information on this page is for maintenance of the 4. Put the propeller (PKZ5101) on the collet of the propeller Extra 300. Spinner, propeller and propeller adapter damage can adapter (PKZ5102). result from aircraft crashes. Notice: The propeller (PKZ5101) side with the numbers for diameter and pitch (for example 10.5 x 9) should face out from CAUTION: DO NOT handle propeller parts while the... -
Page 16: Motor And Esc Removal
Motor and ESC Removal Note: The information on this page is for maintenance of the Extra 300. Damage to these parts can result from aircraft crashes. Installation of the motor is in reverse order of the steps listed below. The propeller (PKZ5101) must be removed from the motor (PKZ5116) before the cowl (PKZ5126) and motor can be removed from the aircraft. -
Page 17: Pnp Installation
Battery Selection and Installation 1. Install your parkflyer or full range receiver in the fuselage • We recommend the ParkZone 2200mAh 11.1V 25C using hook and loop tape or double-sided servo tape. Li-Po battery (PKZ1029). 2. Attach the elevator and rudder servo connectors to the •... -
Page 18: Flying Tips And Repairs
Note: The Parkzone Extra 3oo is a high performance aircraft. Full power should only be used for vertical climbs. Avoid high power Repairs settings in dives or tight turns. -
Page 19: Troubleshooting Guide
Troubleshooting Guide Problem Possible Cause Solution • Aircraft will not respond to throttle • Throttle not at idle at control setup so • Reset controls with throttle stick and but responds to other controls throttle not armed throttle trim at lowest setting. •... -
Page 20: Replacement Parts And Optional Parts
EC3 Device and Battery Connector, Male/Female Optional EFLC505 1- to 5-cell Li-Po Battery Charger with Balancer Optional PKZ1029 ParkZone 2200mAh 11.1V 25C Li-Po battery Recommended for size, weight and power in Extra 300 PKZ1059 SV80 Aileron Servo, 200mm: Extra 300 Recommended aileron servo PKZ1090... -
Page 21: Warranty And Service
Warranty and Repair Policy Warranty Period Law: These Terms are governed by Illinois law (without regard to conflict of law principals). Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from Warranty Services defects in materials and workmanship at the date of purchase Questions, Assistance, and Repairs by the Purchaser. -
Page 22: Contact Information
Declaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2010042201 Product(s): Extra 300 BNF, Extra 300 PNP Item Number(s): PKZ5180, PKZ5175 Equipment class: The object of declaration described above is in conformity with the requirements of the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC:...
Need help?
Do you have a question about the Extra 300 PNP and is the answer not in the manual?
Questions and answers