Mounting The Control Unit; Mounting The Siren; Mounting The Shock Sensor - Scytek electronic G777 Product Manual

Mounting the Control Unit

The control unit must only be mounted in the interior of the vehicle. Do not mount the main
unit in the engine compartment. Choose a mounting location that will not be easily
accessible to a thief, and will not interfere with the operation of any vehicle components
such as foot pedals, steering column, air vents, seat rails, etc.
Do not mount the control unit until after setting the internal jumpers and performing a
complete operation check of the system. After installation is complete and performance
verified, the control unit can be easily mounted using wire ties through the mounting tabs on
the bottom of the unit.

Mounting the Siren

Choose a siren mounting location that is away from heat sources such as exhaust
manifolds, and where it cannot be easily accessed from underneath the vehicle. Be sure to
face the siren downward to prevent the collection of water in the siren's housing.
Always route all wires from the engine compartment into the interior of the vehicle through
a proper grommet.

Mounting the Shock Sensor

Choose a suitable interior mounting location for the shock sensor that provides ample
coverage of the vehicle. Keep the sensor away from the vehicle's ECM or other sources of
electrical interference. Suggested mounting locations include air conditioning ducts,
dashboard braces, or center console supports.
During proper operation, the shock sensor will detect impacts to the vehicle only and will not
usually be triggered by slow rocking movements of the vehicle like those caused by wind.
G777,G27,A777,A20 - Page 15