Comfort Glow 23-800-001 Owner's Installation And Operating Instructions page 11

Fahrenheit/Celsius Display:
5
This button displays F (Fahrenheit) or C (Celsius) depending on how the temperature mode is set.
When the fireplace is first turned on, the Fahrenheit (F) temperature will be displayed. To switch
from Fahrenheit to Celsius, or vise-versa, when HEATER is ON, hold HEATER CONTROL button
for 10 seconds. The fireplace will remember the last temperature mode setting, and in later use,
the display will start at that setting, unless power to the unit has been interrupted.
6 Temperature/Timer Display
This LED display shows the set point for the temperature and timer functions. When either of
these functions is activated, the display reflects the set point for five seconds and then fades to
black. Any change in the set point of the temperature or timer will reactivate the display, which
again fades after five seconds.
The infrared remote control relies on a line of sight and must be pointed at the flame/screen of the
fireplace to work. The remote control unit has the controls required to turn ON/OFF both the main
power and the heater. If you prefer to use the touchpad control on the fireplace unit itself, open the
control panel sliding cover to access the touchpad buttons.The layout of the buttons on touchpads
and remote control unit can be seen in Figures 4 and 6, respectively.
1. Plug your fireplace into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the back screen
of the fireplace.
3. Remove plastic tab from inside battery compartment
to activate remote control.
4. Point the remote control directly at the fireplace
flame/screen and use the buttons to operate the
fireplace.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction
CR2025
PUSH
RELEASE
OPEN
Figure 5
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
11
(Pull tab)