Toshiba e-STUDIO203 Service Handbook page 180

6) Poor fusing
Defective area
Heater electric power
Pressure between fuser
roller and pressure roller
Fuser roller temperature
Developer material/Toner
Paper
e-STUDIO163/203 TROUBLESHOOTING
Step Check items
1 Check if the connector contacts prop-
erly.
2 Is the heater shorted or broken?
3 Are the pressure springs working
properly?
4 Is the temperature of the fuser roller
normal?
5 Using the specified developer mate-
rial and toner?
6 Is the paper in the drawer damp?
7 Is the paper type corresponding to its
mode?
8 Is the setting temperature of the fuser
roller in each paper type normal?
9 Using the recommended paper?
Fig. 5-6
Correct it.
Replace the heater.
Check and adjust the pressure
springs.
Check the setting and correct it.
08-407, 410, 411, 450, 515, 516
Use the specified developer material
and toner.
Avoid storing paper in damp place.
Use the proper type of paper or
select the proper mode.
Check the setting and correct it.
08-413, 437, 438, 451, 452, 453,
520, 521
Use the recommended paper.
5 - 24
Prescription
December 2005 © TOSHIBA TEC