Sequence Setting; Power On Resume & Md Dwell Time - Samsung SPU-3750T User Manual

Functional Description

Sequence Setting

9. Power On Resume and MD Dwell Time
▶ Main Menu/Sequence Setting
Power On Resume :
Main Menu
This is useful when the power is disconnected and
① Camera Setting
reconnected due to power failures or other power
② Sequence Setting
interruptions.
③ P/T Setting
If the camera was performing a sequence action prior to a
④ OSD Setting
power disconnection, the camera automatically resumes
⑤ Alarm Setting
the action when the power is reconnected.
⑥ Initialize
MD Dwell Time :
 Status
When Motion Detection under the Preset Edit menu is
➡
selected, MD Dwell Time performs the Tour or Group
function.
Sequence Setting
While the camera is performing a sequence action, if
① Preset
motion is detected from a selected preset location, the
② Swing SEQ
camera pauses the sequence action operation and starts
③ Group SEQ
monitoring the location instead for a duration that is set
④ Tour SEQ
under the MD Dwell Time menu.
⑤ PTZ Trace
If the motion is no longer detectable or the duration
⑥ Auto Run
expires, the camera aborts the monitoring operation and
 Power On Resume ON
then resumes the sequence action.
 MD Dwell Time
ON
58
SPEED DOME CAMERA User's Manual
Functional Description
10. Preset
10.1 Preset Location Saving
▶ Main Menu/Sequence Setting/Preset/Setting
This function enables the memorization of a selected location
Main Menu
and activates the Pan, Tilt, and Zoom functions at that location.
① Camera Setting
Saved locations can be recalled using the Preset Execute
② Sequence Setting
command.
③ P/T Setting
④ OSD Setting Setting Up Preset Numbers :
⑤ Alarm Setting
Selecting the Preset Setting menu brings up a screen as
⑥ Initialize
shown below. Move the joystick in all four directions to
 Status
select the desired number.
➡
Sequence Setting
① Preset
② Swing SEQ
③ Group SEQ
Saving Preset Locations :
④ Tour SEQ
Selecting a preset number and pressing the Enter key
⑤ PTZ Trace
redirects the menu to the screen shown below.
⑥ Auto Run
Using the joystick, adjust the location of the Pan and Tilt
 Power On Resume ON
functions and then set the Zoom and Focus command.
 MD Dwell Time OFF
In Preset Settings, the Zoom and Focus command is
➡
controllable only by the Zoom command. To switch
between Zoom and Focus, use the Preset 1 and 2
Preset
commands as shown below.
 Setting
 Edit
 Home Position OFF
 Execute
 Clear
 Status
SPEED DOME CAMERA
Preset Setting
Preset = 001 (255)
Preset Setting Z>Z00M
1+PST:ZOOM 2+PST:FOCUS
Use W/T Preset
59
User's Manual