Konig SAS-DVRSET35 Manual page 30

¾ Record Channel: allow you select channels you want to record.
¾ Post Recording: you can set how long alarm record will last when alarm ends
(30s, 1minute, 2minutes, 5minutes).
¾ Copy: allow you copy all the setting of one channel to other ones.
Alarm Type
Video Loss Sends alarm when DVR can't receive video signal (such as camera
damage, cable broken or damaged or power supply malfunction).
Motion Detection When an object moves into motion detection area, alarm will be
triggered. You can adjust sensitivity level to suit the needs of your
actual application environment.
I/O Status System can convert alarm signal triggered by external sensor into signal
identified by system.
HDD loss When Hard Drive is not detected (HDD damage, power supply
malfunction), or HDD auto-overwrite is off, and free space is not
enough, an alarm will be triggered.
5�2�6 Device
5�2�6�1 HDD Set
Click [Main menuDeviceHDD] to enter into the interface shown as Picture 5-45.
Picture 5-45
When DVR is connected to a HDD, the system will automatically detect if HDD is normal or not;
If the cable connected to HDD is loosen or HDD is abnormal, HDD status will be shown as "No
Disk", or, If HDD need to be formatted, status will be shown as "no format", otherwise, the HDD
status will be shown as "Normal"
¾ NO: indicate HDD no pre-seted by system.
¾ Status: It will be available only when HDD have been formatted.
¾ Total Space: Total size of the hard drive currently installed.
¾ Free Space: Total amount of free space available on the hard drive currently installed.
¾ Useable Rec. Time: Free space currently available in hours.
Function
List 5-1
Picture 5-46
30
ENGLISH