Table of Contents
Advertisement
O
perations
getting ready continued
d. Replace the insert assembly and cap,
tighten until snug.
e. Replace the water tank by lining up
the vertical guides and gently sliding it
back into place.
3. Twist the quick release cord wrap
clockwise to unwrap the power cord
completely, make sure both switches are
in the off position and plug it into a
proper outlet.
4. Turn power button on. The ready light will
illuminate when the Steam & Sweep is
ready for use.
note: upon first use of the steam
& sweep or first use of a new filter,
the pump may make a "knock-
ing" sound while the filter fills
with water. this sound is normal
and may last a couple of minutes.
continue to depress the trigger until
the knocking sound subsides and
the unit emits steam. if the sound
continues, please make sure the
tanks are firmly secured."
before you clean
the steam & sweep can be used as a
sweeper and a steam mop at the same
time. for best results, use the steam
& sweep's powerful sweeper to clear
floor of dust and small debris before
mopping.
1. Turn the brush switch to the oN position
to activate the brush.
2. To empty the dirt container, turn the power
off, gently tap the release pedal on the
swivel head. Lift unit straight up leaving
bin on floor and empty into a trash can.
The dirt container may be warm to the
touch.
3. Replace the dirt container by
pushing it back into the swivel head until
it snaps back into place.
w w w . b i s s e l l . c o m
2d.
WaRning:
Steam & Sweep will not
pick up crayons, marbles,
and other large objects.
Brush Switch
Dirt Bin
2.
Release Pedal
2e.
Power Switch
7
Advertisement
Table of Contents
