Table of Contents
Advertisement
A
Product View
Do not plug in your cleaner until you have
completely assembled it per the following
instructions and are familiar with all
instructions and operating procedures.
1 Spray Trigger
2 Upper Handle
3 Retractable Handle Lock
4 Power Cable
5 Upper Body
6 Formula & Water Tank
7 Vent Cover (Foam Filter)
8 Dirty Water Tank Latch
9 Removable Nozzle
Cleaning Formulas
Always use genuine BISSELL deep cleaning
formulas. Non-BISSELL cleaning formulas may
harm the cleaner and may void the guarantee.
10 1.5 L 2X Wash & Protect PRO Professional Stain & Odour Formula
w/ Scotchgard™ Protector
11 1.5 L 2X Wash & Protect PET Pet Stain & Odour Formula
w/ Scotchgard™ Protector
12 1.5 L 2X Wash & Protect Stain & Odour Formula
w/ Scotchgard™ Protector
13 1.5 L 2X* Wash & Refresh Blossom & Breeze
w/ Febreze™ Freshness
*2X concentrated formula, 60 mL is equivalent to 120 mL of non-
concentrated formula
To reduce the risk of fire and electric shock
due to internal component damage, use only
BISSELL cleaning fluids intended for use with
the deep cleaner.
To reduce the risk of fire, use only BISSELL deep
cleaning formula for full size machines in your
deep cleaner. Use of cleaning formulas that
contain lemon or pine oil may damage this appliance and
void the guarantee. Chemical spot cleaners or solvent-based
soil removers should not be used. These products may react
with the plastic materials used in your deep cleaner causing
cracking or pitting.
Scotchgard™ is a trademark of 3M®.
Febreze and related trademarks are owned by The Procter & Gamble Company, Cincinnati, Ohio, and used under
license by BISSELL Homecare, Inc.
6
www.BISSELL.eu
B
Assembly
Your deep cleaner assembles quickly and
easily. The only tool you will need for
assembly is a Phillips-head screwdriver.
1. Slide Upper Body onto Lower Body. Make
sure there is no gap between Upper and
Lower Body.
2. Firmly holding Upper Body, screw two
screws into holes marked with arrows.
If tightening screws is difficult, remove,
re-insert, and tighten again.
3. If assembled properly, there should be
no gap between Upper and Lower Body. If a
gap appears, continue to tighten screws until
no gap is present.
4. Slide Upper Handle into Upper Body by
aligning pin and sliding into place.
NOTE: Be sure to secure Upper Handle
before lifting. Rotate Handle Lock clockwise
to secure.
5. Place Formula and Water Tank on back
of unit.
6. Wrap Power Cable around Cable Wraps.
Assembly is now complete.
C
Operations
Before you clean
1. Plan activities to give carpet time to dry.
2. Move furniture to another area if cleaning
entire room (optional).
3. Vacuum area with a dry vacuum cleaner
thoroughly before deep cleaning.
4. Plan your cleaning route to leave an
exit path. It is best to begin cleaning in
the corner farthest from your exit.
Advertisement
Table of Contents
