Electronics Line infiniti User Manual page 19

The TX list displays the following information for
each transmitter:
The transmitter's descriptor
The signal strength of the last received
transmission
An abbreviation indicating the last received
status of the transmitter.
This...
OK
TA
BT
OS
NA
Audio Volume
To adjust the sensitivity of the microphone and the volume of the speaker:
1. Establish a two-way audio connection.
2. From the Service menu, select Audio Volume [77]; the current setting is displayed.
3. Adjust the setting according to the following table.
Press...
1
4
3
6
4. Press ; the new settings are stored in the memory.
GSM Signal Strength
You can measure the GSM signal strength using the system's RSSI (Received Signal
Strength Indication) meter.
To view the GSM signal strength reading:
•
From the Service menu, select GSM Signal [78]; the signal strength of the
cellular network is displayed.
This reading...
8 to 9
5 to 7
Less than 5
Display Version
To display the system's software and hardware versions:
•
From the Service menu, select Version [79]; the software (SW) and hardware
(HW) versions are displayed.
Means...
The transmitter is functioning correctly
Tamper condition
Battery low
The transmitter is out of
synchronization
The transmitter is inactive
To...
Increase microphone sensitivity
Reduce microphone sensitivity
Increase speaker volume
Reduce speaker volume
Means...
Reception is good
Reception is acceptable
Reception is unacceptable
FRONT DOOR
S=6 OK
-19-
Press this key to
display the transmitter's
default descriptor .
Notify
your
installer