Panasonic Lumix DMC-ZS40 Operating Instructions Manual page 267

GPS
■
Using "GPS Assist Tool" by connecting the camera and computer
Preparation:
Turn on the computer and close all other open application programmes.
Select [Assist Data] from [GPS] menu and press [MENU/SET]
Use to select [Update] and press [MENU/SET]
Use to select [Connect USB] and press [MENU/SET]
Connect the camera to a computer
[Access] (sending data)
• Do not disconnect
the USB connection
cable (supplied) while
[Access] is displayed.
Start up the "GPS Assist Tool" on your computer and update
the GPS assist data
The GPS assist data of the camera is updated.
Terminate the connection between the camera and computer
and disconnect the USB connection cable (supplied)
●
You can also update the assist data if you select [GPS assist data] for [USB Mode]
(→72) when you connect the camera to a computer.
●
Do not use any other USB connection cables except the supplied one or a genuine
Panasonic USB connection cable (optional). Using cables other than the above may
cause a malfunction.
Check the plug direction and insert it straight in.
(If the cable is inserted in the wrong direction, the
plug could become deformed and cause faulty
operation)
Also, do not insert into the wrong socket. Doing so
may cause damage to this unit.
USB connection cable (supplied)
(→269)
- 267 -
Reducing the time required for positioning
VQT5E94