Mounting The Housing - Bosch UHI-SBG-0 Installation Manual

UHI-SBG-0 Series
6

Mounting the Housing

The UHI-SBG-0 housing includes a J-mount which features a removable camera bracket and
locking grooves to keep the housing from drooping. The mount is vertically adjustable by
pushing the housing up or down.
Mounting Procedure
1.
2.
.
Fig. 6.1 Feeding the Wire using the Bottom NPT Fittings
Fig. 6.2 Feeding the Wire using the Rear NPT Fittings
3.
Fig. 6.3 Mounting the J-mount and Housing
4.
5.
Bosch Security Systems, Inc.
Determine a proper location for the housing.
Insert the coax and power lead wires from the wall through the supplied J-mount allow-
ing enough slack to pull through the housing (see Figure 6.1 on page 9 if using the bottom
glands or see Figure 6.2 on page 9 if using the rear glands).
Prepare the surface for mounting and install the J-mount.
Place the UHI-SBG-0 housing on top of the J-mount while feeding the wires through the
bottom or rear NPT fittings.
Make sure that the weight of the camera is distributed evenly.
Installation Manual
Mounting the Housing
September 15, 2006 | F01U032279_01
9