4.5
Entering parameter editing mode
When the system boot up and the hard disks are also in good condition, the LCD will display the
device name and IP (at the first time boot up, the IP will be the default IP). Shown as follows:
D C - 2 0 1 0
1 9 2 . 1 6 8 . 0 . 1 2 0
Now the device is waiting for manual input to configure from panel. With the touch wheel and
touch confirmation button, you can go through all the basic settings.
Touch the confirmation button more than 3 seconds to activate the setting message:
P W D : _ _ _ _ _ _
0 1 2 3 4 5 6 7 8 9
Input the password (default is 000000, 6 zeros), if you forget pass word, please keep
the confirmation button touched for more than 3 s to restore the default password.
P W D : * * * * * *
0 1 2 3 4 5 6 7 8 9
Select confirm to input data to DC2010
P a s s w o r d
P l e a s e
If password error, try again.
If password correct, the system entering parameter editing mode.
Rotate the touch wheel, you can go through each page and select the desired page
by confirmation button to enter the mode.
S y s t e m
←
Display system information
L C D
←
Adjust and setting the LCD backlight
S c r e e n s a v e r
←
Adjust the LCD screen saver time
N e t w o r k
←
Ethernet settings
U S B
←
External USB backup
← →
← →
E r r o r
T r y
S u m m a r y
B a c k l i g h t
S e t t i n g
B a c k u p
↵ ↑
↵ ↑
A g a i n
→
→
t i m e
→
→
→
15
Need help?
Do you have a question about the DC2010 and is the answer not in the manual?