RIDGID R4512 Operator's Manual page 39

OPERATION
MAKING A BEVEL CROSS CUT
See Figures 61 - 62.
WARNING:
Make sure the blade guard assembly is installed
and working properly to avoid possible serious
injury.
WARNING:
The miter gauge must be on the right side of the
blade to avoid trapping the wood and causing
kickback and the risk of serious personal injury.
 Remove the rip fence.
 Loosen the bevel lock knob.
 Adjust the bevel angle to the desired setting.
 Tighten the bevel lock knob.
 Set the blade to the correct depth for the workpiece.
 Set the miter gauge to 0° and tighten the lock knob.
 Make sure the wood is clear of the blade before turning
on the saw.
 Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.
 Hold the workpiece firmly with both hands on the miter
gauge and feed the workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
 When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
vIewed frOM THe SIde, BeLOw THe TaBLe Saw
TO LOCK
BeveL CrOSS CUT
BLade
angLed
39
TO UnLOCK
BeveL LOCK
KnOB
Fig. 61
MITer gaUge
STraIgHT
Fig. 62