RIDGID R4512 Operator's Manual page 18

ASSEMBLY
INSTALLING THE TABLE EXTENSIONS
See Figures 10 - 11.
NOTE: It is helpful to place two inch-thick boards on the floor
before lifting the saw table and motor housing from the box.
This will make it easier to assemble parts, and to move the
saw and set it upright.
Lift the saw table and motor housing from the box and

position it on the boards as shown.
Loosen the plastic wrap from the table and lift each side

to remove the wrapping.
From the large fastener pack, locate the following parts:

6 Bolts (M10 x 25)
6 Lock washers (M10)
6 Flat washers (M10)
With the table saw in the upside down position, place a

table extension against the table top, on the same side as
the power cord. The larger holes in the extension should
be aligned with the holes in the saw table.
Make sure the edges of the table extensions are aligned

with the edges of the table.
Insert a lock washer and flat washer over a bolt. Thread

the bolt into the holes in the table extension and saw
table. Repeat for the two remaining holes.
 Repeat above step on the other table extension.
Using an 8 mm socket, tighten the socket head bolts. Do

not tighten completely.
ASSEMBLING THE LEG STAND
See Figure 12.
Locate the following parts:

4 Leg stand sections
4 Outer corners
From the small fastener pack, locate the following parts:

24 Bolts (M6 x 10)
Place an outer corner outside a leg stand section.

NOTE: The top of the outer corner has a bent tab and
hole for assembly to the saw cabinet.
Insert a bolt into each of the three holes and finger tighten.

Repeat with remaining corners and leg stand sections.

Using a 4 mm hex key, tighten all bolts securely.

NOTE: The front of the stand is the section with the
English WARNING label attached.
BOaRdS
FLaT
WaSHER
LOCK
WaSHER
TaBLE
EXTENSION
LEg STaNd
SECTION
OuTER
CORNER
18
SaW
TaBLE
Fig. 10
TaBLE
EXTENSION
SaW
TaBLE
BOLT
Fig. 11
BOLT
Fig. 12