Suspended Ceiling Mount - Lightspeed FP 1000 User Manual

2. IR SENSOR INSTALLATION

Suspended Ceiling Mount

the ceiling tile nearest the grid rail in
1. Lift
your desired sensor location. Guide one
side of the C-clip over one edge of the
grid rail. Providing firm support to the
back of the grid rail with one hand (to
prevent bending), firmly and carefully
snap the second side of the C-clip over
the edge of the rail.
sensor wire. Connect one
2. Uncoil
end of the sensor cable to the plug on
the sensor. Secure wire overhead and
route it back to
the system.
the other end of the sensor
3. Connect
cable into one of the sensor inputs on
the back of the system.
CONT'D
Wall/Solid Ceiling Mount
wall
mounting
strip
1. Screw the plastic mounting strip to a place
high on the wall or in the middle of the
solid ceiling. Mount the strip horizontally
as shown above.
snap the C-clip on the back of the
2. Firmly
IR sensor onto the plastic mounting strip
with the sensor plug hanging down (if a
wall mount) or toward the receiver location
(if ceiling mount).
the sensor wire. Screw one end
3. Uncoil
of the sensor cable to the plug on the
sensor. Route the wire back to the system,
securing it along
the way.
the other end of the sensor cable
4. Connect
to one of the sensor inputs on the back of
the system.
c-clip
sensor plug
13