Appendix 1. The X-Cam A10-3H Sensor Advanced Calibration Guide - X-cam A10-3H User Manual

Appendix 1. The X-CAM A10-3H Sensor Advanced Calibration Guide
1. Connect the USB cable to the PC and launch the X-CAM Gimbal Assistant Software,then power on the X-CAM
A10-3H.
2. Clickthebuttonof"Connect"andclickthebuttonof"ReadParams",youwillhearbeep-beep.
  Notice:PleasebackuptheDrivenVoltagevaluesandServoReversevalues(asthepicture1shows)beforecalibrate.
                                     (Picture1)
3. Clickthebuttonof"initializeParams".Thenyouwillhearthreebeep(beep-beepandbeep),pleaseinput"0"to 
theDrivenVoltage.Thenclickthebuttonof"BurnParams",Youwillhearbeep-beep-beepthatmeansithasbeen
burnedintotheX-CAMA10-3H.(donotdoubleclick)
4. (1)Togglethegimbalverticaltotheground(90degree).Putthebubblelevelonthesensor.
 
（Picture2)  
  （2)Adjustthecameratokeepthebubbleatthecenterpositionmanually.Clickthebuttonof"Auto
Calibrate"(Picture3)
Notice:whenyouclickthebuttonof"AutoCalibrate",pleasekeepthebubbleatthecenterposition(picture2).(If
failed,pleasetryagain)
  （3）Afterthecalibration,clickthebuttonof"Disconnect",andpowerofftheX-CAMA10-3H.Thenre-powerthe
   

(Picture3)