Table of Contents
Advertisement
.El Design
eldesign.dk
Schedule Help
If you have set Firewall Rules on the "Rules" screen or Keyword Filtering on the "Block Sites"
screen, you can set up a schedule for when the rules are applied.
To apply Rules based on a schedule:
1. On the "Rules" screen, create the required Rules, using either "Block by Schedule" or
"Allow by Schedule" for each rule, as required.
2. Select the Use this schedule for rules checkbox on this screen.
3. Select the days and times on this screen, as required.
4. Click Apply.
Note: If the schedule is disabled on this screen, this affects ALL Rules which are using a schedule.
Days
Select the required days
• Every Day - all days will automatically be selected
• Sunday, Monday .. If "Every Day" is NOT selected, you can choose the required days
individually.
Time of day
This determines when the schedule is applied, for each day selected above. Enter the desired Start
and Finish times.
Note: Enter the values as 24-hour time. For example, 10:30 am would be 10 hours and 30 minutes
and 10:30 pm would be 22 hours and 30 minutes.
Timezone
The Router will determine the current time and date by contacting a Network Time (NTP) Server on
the Internet. In order to display your local time, you must select your Time Zone from the list.
If your region uses Daylight Savings Time, you must manually check Adjust for Daylight Savings
Time at the beginning of the adjustment period, and uncheck it at the end of the Daylight Savings
period.
Use this NTP Server
If you prefer to use a particular NTP server as the primary server, check the checkbox Use this NTP
Server and enter the Server's IP address under Use this NTP Server.
If this setting is not enabled, the default NTP Servers are used.
To Accept Or Cancel
Click Apply to save changes.
Click Cancel to disregard any unsaved changes.
NETGEAR DSL VVG2000
24/48
Advertisement
Table of Contents
