LightwaveRF LW450 Connect Series Instruction Manual page 10

Installation
8.
Replace the plate – a 'click' sound
should be heard to signify that the plate
has been correctly replaced.
Important things to Consider
• Wattage ratings for the Dimmers are
per gang. The maximum circuit load for
each 2-Way Dimmer Gang is equal to
the maximum load on the standard
LightwaveRF Dimmer it is connected to
(i.e. 250W or 210W).
• ONLY Dimmable lamps can be used even if the Dimmers are used solely to
switch between the on and o
technology used in an electronic dimmer is fundamentally di erent to that
of a simple on/o switch and requires compatible lamp technology.
NOTE: Compatibility between electronic Dimmers and LEDs can be a ected
if the total circuit loading is very small. Total LED load decreases (relatively)
as it is shared between a greater number of connected Dimmers; therefore,
as more 2-Way Dimmers (up to 6) are added to a single circuit, it is possible
that LED performance may become less stable.
states without dimming. This is because the