Table of Contents
Advertisement
The NHL 15 is equipped with a large 15 litre NuChem / water tank allowing large areas to be cleaned in a
single fill.
To fill the clean water tank remove the waste water tank and fill using hose, bucket or a suitable container (Fig 17).
Fill to the MAX level mark (Fig 18) located on the inside of the drum.
Ensure the clean water goes into the container and not the central tube.
Note.
Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc) are not allowed to enter the
NuChem / water tank during the filling process.
If using a bucket or similar container, ensure it is always clean and free from debris.
Caution:-
Avoid tipping water into the central tube this is leads directly to the vacuum motor (Fig 19).
Fig 17
Removing the dome and waste-water tank.
Fig 14
Fig 15
Filling the Nuchem / water tank.
Fig 18
Fig 19
233935 Page 10 06/11 (A04)
To remove the dome, unclip the locking toggles and lift
the dome off the machine (Fig 14).
The waste water tank is held into place with a red locking
clamp. Undo the clamp (Fig 15) and lift the waste water
tank from the machine (Fig 16).
Fig 16
Advertisement
Table of Contents
