Operating Temperature; Manual Operation - Midea FLAIR User Manual

OPERATING INSTRUCTIONS
NOTE: This manual does not include Remote Controller Operations, see the
<<Remote Controller Instruction>> packed with the unit for details.

Operating temperature

Mode
Temperature
Room temperature
Outdoor temperature
NOTE:
1. Optimum performance will be achieved within these operating temperatures.If air
conditioner is used outside of the above conditions, certain safety protection features
might come into operation and cause the unit to function abnormally.
2. Room relative humidity less than 80%. If the air conditioner operates in excess of this
figure, the surface of the air conditioner may attract condensation. Please sets the vertical
air flow louver to its maximum angle (vertically to the floor), and set HIGH fan mode.

Manual operation

Units are equipped with a switch to run emergency operation mode. It can be accessed by
opening the front panel. This switch is used for manual operation in case the remote controller
fails to work or maintenance necessary.
Manual switch
AUTO/COOL
Manual switch
Cooling operation
17 32
62 90
18 43
64 109
-7 43 20 109
( For the models with low
temperature cooling system
18 52 64 126
(For special tropical models)
AUTO/COOL
(1)
Suspension bars
(2)
Heating operation
0 30
32 86
-7 24
20 76
Hold the panel sides and lift the front panel
1
up to an angle until it remains fixed with a
clicking sound.
Once you push the manual switch, the
2
operation mode is shifted in an order as:
AUTO, COOL, OFF. The temperature will
O
be set at 24 C/76 F and the fan on Auto.
After operation, close the panel firmly to its
3
original position.
CAUTION:
This switch is used for testing purposes
•
only. You had better not choose it.
To restore the remote controller operation,
•
use the remote controller directly.
6
Drying operation
10 32 50 90
11 43 52 109
18 52 64 126
(For special tropical models)
O