Indoor Unit Installation; Installing The Wall Hang Bracket - Carrier 53P100C Owners And Installation Manual

INDOOR UNIT INSTALLATION

• The piping can be connected to the four directions indicated by ³, ·, », ¿. When the piping is connected
to the direction of , or , detach the knock-out either at the side or at the bottom of the unit. ( Fig. 3 )
»
³
·
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0

1) Installing the Wall Hang Bracket

1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
REMOVE SCREW
• Install the wall hang bracket so that it is level. Use a plumb line if necessary. ( Figure. 4 )
• Be sure to leave the clearance spaces shown in Figure 1.
• Before installing the wall hang bracket, remove it from the unit by pushing up marks (
• Fasten the wall hang bracket to the wall with 5 or more self-tapping screws through the holes near the outer edge of the
bracket as shown in Figure 4.
• Install the wall hang bracket so that there is no gap between the bracket and the wall.
• Check that the wall hang bracket does not move to prevent noise during operation.
22
Page 4
¿
Figure 3
30cm
or more
PLUMB
) at the bottom of the body.
NOTE
10cm
or more
• In case of removing the unit
from the wall hang bracket
after installing it onto the wall,
45cm remove by pushing up
or more
MARKS ( ) at the bottom of
the body.
Figure 4
2004.3.30, 6:35 PM