Installation Requirements; Tools And Parts; Location Requirements - KitchenAid 528534 Installation Instructions Manual

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
■ Utility knife
■ Needle-nose pliers
■
Tape measure
■ Flat-bladed screwdriver
■
#2 Phillips screwdriver
■ Side cutting pliers
■
Pencil
■ Sandpaper
■ Level
■
Adjustable wrench that
opens to 1 " (29 mm)
Parts supplied:
Located in drawer:
■ 2 flexible trim pieces (for sides)
■
Edge protection
■ Hose clamp, screw type
■ Washer
■
Drain hose support
■ Drain hose connector
■
Hose clamp, wire type
■ 11, " long, #8 Phillips head wood screws
■
Moisture protection tape
■ 3, 1" hex head wood screws
■ 3, " washers

INSTALLATION REQUIREMENTS

■ 7 mm socket wrench
■
5 mm socket wrench
■ 5 mm open end or box end
wrench
■
Electric or hand drill
■ 1 " hole saw
■
Valve (sized to fit hot water
supply line) with " male
compression fitting
■
Protective floor covering

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
■ Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
■ Install the dishwasher as specified in these instructions.
■ Have everything you need to properly install dishwasher.
■
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
■
This dishwasher is manufactured for indoor use only.
■ Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 lbs. (47 kg), and is in an area suitable for its
size and use.
Product dimensions
*
22 "
(57 cm)
16 "
(40.9 cm)
20 "
(52 cm)
drawer open
*
If custom wood panels are to be used, the product depth is specified with an
" (18 mm) door panel thickness.
NOTE: Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
■ " (2250 mm): Extension kit available - part
Drain hose 88
■ no. 8194400
■
Inlet hose 68 " (1750 mm)
■ Power cord 44" (1125 mm)
23 "
(59.5 cm)
side
attaching
tabs
3