Important Safety Instructions; Important Safeguards - GBC 2064WF-1 Installation And Operating Manual

GBC 2064WF-1

IMPORTANT SAFETY INSTRUCTIONS

YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO GBC. IN THIS INSTRUCTION MANUAL
AND ON THE PRODUCT, YOU WILL FIND IMPORTANT
SAFETY MESSAGES REGARDING THE PRODUCT. READ
THESE MESSAGES CAREFULLY. READ ALL OF THE
INSTRUCTIONS AND SAVE THESE INSTRUCTIONS FOR
LATER USE.
THE SAFETY ALERT SYMBOL PRECEDES
EACH SAFETY
INSTRUCTION MANUAL.
INDICATES A POTENTIAL PERSONAL SAFETY
HAZARD TO YOU
FOLLOWING WARNINGS ARE FOUND UPON
THIS PRODUCT.
ADVERTENCIA Attention
Riesgo de choque Risque de
eléctrico Secousseélectrique.
No abra: Ne pas ouvrir.
Adentro no hay Pas de pièces
piezas reparables réparables par
por el usuario. l'utilisateur.
Mantenimiento Entretien
solamente por seulement par
personal calificado personnel qualifié.
THIS SAFETY MESSAGE MEANS THAT YOU COULD BE
SERIOUSLY HURT OR KILLED IF YOU OPEN THE
PRODUCT AND EXPOSE YOURSELF TO HAZARDOUS
VOLTAGE.
ADVERTENCIA Attention
RODILLOS ROULEAUX
CALIENTES. CHAUDS.
PUNTO DE POINT DE
PINCHAMIENTO. PINCEMENT.
Mantener manos y Tenir mains et
ropa a distancia. vêtements à
l'écart.
THIS SAFETY MESSAGE MEANS THAT YOU COULD BE
BURNED AND YOUR FINGERS COULD BE TRAPPED
AND CRUSHED IN THE HOT ROLLERS. CLOTHING,
JEWELRY AND LONG HAIR COULD BE CAUGHT IN THE
ROLLERS AND PULL YOU INTO THEM.
ADVERTENCIA
Attention
NAVAJA FILOSA. LAME
COUPANTE.
Mantener manos y
dedos a distancia. Tenir mains et
doigts à l'écart.
THIS SAFETY MESSAGE MEANS THAT YOU COULD
CUT YOURSELF IF YOU ARE NOT CAREFUL.
WARNING: THIS SAFETY ALERT SYMBOL
PRECEDES EACH SAFETY MESSAGE IN THIS
INSTRUCTION MANUAL.
INDICATES A POTENTAL PERSONAL SAFETY
HAZARD TO YOU OR OTHERS.
WARNING: DO NOT ATTEMPT TO SERVICE OR
REPAIR THE 3064 WF LAMINATOR.
WARNING: DO
LAMINATOR TO AN ELECTRICAL SUPPLY OR
ATTEMPT TO OPERATE THE LAMINATOR
UNTIL YOU HAVE COMPLETELY READ THESE
INSTRUCTIONS.
INSTRUCTIONS IN A CONVENIENT LOCATION
FOR FUTURE REFERENCE.
© 2009 General Binding Corporation an ACCO Brands CO.
MESSAGE IN THIS
THE SYMBOL
OR OTHERS. THE
Avertissement
Electrical shock
hazard.
Do not open.
No user serviceable
parts inside.
Refer servicing to
qualified service
personnel.
Avertissement
HOT ROLLS.
PINCH POINT.
Keep hands and
clothing away.
Avertissement
SHARP BLADE.
Keep hands and
clothing away.
THE SYMBOL
NOT CONNECT THE
MAINTAIN THESE

IMPORTANT SAFEGUARDS

WARNING: TO GUARD AGAINST INJURY THE
FOLLOWING SAFETY PRECAUTIONS MUST BE
OBSERVED IN INSTALLATION AND USE OF
THE LAMINATOR.
General:
Keep hands, long hair, loose clothing, and articles such as
necklaces or ties away from the front of the heat and pull
rollers to avoid entanglement and entrapment.
The heat rollers can reach temperatures over 300˚F (150°C).
Avoid contact with the heat rollers during operation or shortly
after power has been removed from the laminator.
Keep hands and fingers away from the path of the sharp film
cutter blade located at the film exit.
Do not use the laminator for other than its intended purpose.
Avoid moving the Laminator on uneven floor surfaces. Never
tilt the laminator.
Do not defeat or remove electrical and mechanical safety
equipment such as interlocks, shields and guards.
Do not insert objects unsuitable for laminating or expose the
equipment to liquids.
Electrical:
The Laminator should be connected only to a source of power
as indicated in these instructions and on the serial plate located
on the rear of the laminator. Contact an electrician should the
attachment plug provided with the Laminator not match the
receptacles at your location.
WARNING: THE
LOCATED NEAR THE
ACCESSIBLE.
Do not operate the Laminator with a damaged power supply
cord or attachment plug, upon occurrence of a malfunction, or
after the laminator has been damaged. Contact GBC's
Technical Service Department or your dealer/distributor for
assistance.
Service:
Perform only the routine maintenance procedures referred to in
these instructions
WARNING: DO NOT ATTEMPT TO SERVICE OR
REPAIR THE LAMINATOR
Disconnect the plug from the receptacle and contact GBC's
Technical Department or your dealer/distributor when one or
more of the following has occurred.
• The power supply cord or attachment plug is damaged.
• Liquid has been spilled into the laminator.
• The laminator is malfunctioning after being mishandled.
• The laminator does not operate as described in these
instructions.
Operation Manual
RECEPTACLE MUST
EQUIPMENT AND EASILY
Page 4
BE