Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alpha Professional Tools WBCKIT
Summary of Contents for Alpha Professional Tools WBCKIT
- Page 1 Wet Blade Cutting Kit Instruction Manual Hook & Loop Strap Coolant Tube GFCI Water Line Blade Guard Garden Hose Adapter *Tool and Blade sold separately Part No: WBCKIT 103 Bauer Drive, Oakland, NJ 07436 • 800-648-7229 • Fax: 800-286-0114 www.alpha-tools.com...
-
Page 2: Table Of Contents
Parts List ....................3 Instructions ................... 3 Creating Thread Holes for the Protective Guard ........4 Assembly of WBCKIT Guard ..............4 Installation of WBCKIT Guard .............. 5 Garden Hose Adapter Installation ............6 Installation of Plastic Wire Wrap ............7 Installation of GFCI ................ -
Page 3: Parts List
PARTS LIST Item Description Part Number Protective Guard for HSG-125 140007 The WBCKIT can also be attached to other grinders with minimal alteration to their safety guards Water Line (10’) 3m* 133287 Garden Hose Adapter* Ground Fault Circuit Interrupter GFCI-1 Hook &... -
Page 4: Creating Thread Holes For The Protective Guard
Hole Size: 5mm or #8 Drill Bit Illustration of Protection Guard 10mm (3/8”) 25mm (1”) ASSEMBLY OF WBCKIT GUARD STEP 1 STEP 2 Thread plastic cable tie through Place coolant tube between holes holes in the guard. (If using another... -
Page 5: Installation Of Wbckit Guard
INSTALLATION OF WBCKIT GUARD Note: It is important to securely attach the WBCKIT to the tool. Groove Before tightening, slide the protective cover onto clamping collar so that the lip on the protective cover fi ts into the groove on the tool. -
Page 6: Garden Hose Adapter Installation
GARDEN HOSE Compression Nut ADAPTER INSTALLATION Base Take the open end of the Push Tube water line and place the compression fitting nut on the tube as shown. Push the tube into the connector base. Water Line Tighten the compression nut with a 14mm wrench to a secure condition. -
Page 7: Installation Of Plastic Wire Wrap
INSTALLATION OF PLASTIC WIRE WRAP Install the plastic wire wrap around both power cord and water-line as shown. Finish the wrapping proce- dure until secure. INSTALLATION OF GFCI Install the GFCI to the grinder power cord as shown. Con- nect to power and check the GFCI for proper function by pressing the test and reset buttons. - Page 8 103 Bauer Drive, Oakland, NJ 07436 • 800-648-7229 • Fax: 800-286-0114 www.alpha-tools.com Copyright © 2009 Alpha Professional Tools. All rights reserved.
Need help?
Do you have a question about the WBCKIT and is the answer not in the manual?
Questions and answers