Miele KM 6113 Operating And Installation Instructions page 50

Problem solving guide
Problem
The sensors are
over-sensitive or do
not react at all.
An F lights up in the
rear left cooking zone
display and an E lights
up in the rear right
cooking zone display
and numbers appear
in the displays at the
front.
left right
9 0
9
9 2
9 3
3 7
4 4
4 7
4 8
All other fault codes
50
Possible cause
The sensitivity level of the
sensors has changed.
A calibration fault has
occurred after the reset
1
function has been
activated or after an
interruption to the power
supply. If the displays do
not go out after 5 minutes,
proceed as described
under "Remedy" on the
right.
The overheating
protection mechanism has
triggered.
There is a fault with the
fan.
A fault with the electronics
has occurred.
Remedy
Make sure that there is no
direct light (from the sun or
from an artificial source)
falling onto the hob and that
the surrounding area is not
too dark.
Make sure that there is
nothing covering the sensors
or the hob. Take any pans off
the hob and wipe away any
food deposits.
Interrupt the power supply to
the hob for approx. 1 minute.
If this does not solve the
problem, please call the
Miele Service department.
You can use the hob again
as soon as the fault code
goes out (see "Overheating
protection").
Ventilation to the underside
of the hob must not be
impaired. Remove any
objects which could block it.
If the fault message appears
again, call the Miele Service
Department.
Interrupt the power supply to
the hob for approx. 1 minute.
If the problem persists after
reconnecting the appliance
to the power supply, please
contact the Miele Service
department.