Operation; Preparation - Global-Tek GT-CR1/BU Instruction & Installation Manual

Global-Tek (Singapore) Pte Ltd
If the impeller does not rotate in the direction of the arrow, DISCONNECT POWER
SUPPLY to the machine and interchange any two power supply leads at the control
box terminal block. Or machine with a circuit breaker, reverse any two leads at the
incoming power supply block in the circuit breaker (three-phase only). Start the
machine momentarily and verify proper direction of rotation.
WARNING: Circuit breakers for booster heater have been switched off before
machine leaving factory to avoid dry operation of the booster elements. SWITCH
ON CIRCUIT ONLY AFTER THE FOLLOWING PROCEDURE. Position and
level the dishwasher; connect electrical power, water inlet and drain pipe. Turn on
the power switch; solenoid valve is activated to fill the machine. When the tanks are
full, Both circuit breakers for booster heater can be switched on now . Failure to
follow this procedure can result in machine manage.

OPERATION

PREPARATION

Put the dishwasher strainer pans and strainer basket into position in each tank. Put
the final rinse screen over the final rinse catch pan.
Hang curtains on open hooks provides to your machine. Be sure long & short
curtains are located correctly.
Close the drain valve at the bottom of the machine and close the door.
Turn POWER switch ON. The pump should be left OFF until the machine has
completely filled.
Recommended temperature for machine are :
Wash Tank Final Rinse
0 0
55-65℃ (130-150 F) 82-95℃(180-198 F)
If the tank is accidentally drained before turning off the power switch, the
float-controlled low-water protector switch will automatically stop the tank heat.
When the proper water level is returned, the tank heat will be automatically started.
DO NOT use the low-water protection as a power ON-OFF switch. The heat MUST
be turned OFF at the POWER switch when the machine is not in use.
Page 9